What Thread On The Cleaning Rod Hawkens 45 Black Powder

Our 29" Creedmoor Rifle Loading and Cleaning Rod is made in the U.s.A. from 5/16" diameter 416 stainless steel. Platonic for heavy duty cleaning, this is our strongest rod for pulling a stuck ball.

This cleaning rod includes a brass rod guide-muzzle protector and wood handle. This sturdy cleaning rod is suitable for .32 caliber and the brass guide centers the rod in larger bores.

The rod working length is well over 29", plus the 1" cleaning jag length. Information technology is an ideal loading and cleaning rod.

This sturdy cleaning rod has 10-32 female person threads to have Thompson Center brand accessories, or Track'south best x-32 threaded jagged tips, brushes, worms, or fouling scrapers.

For your T/C Hawken .45 caliber, we recommend our #JS-45-half-dozen-10 cleaning jag, and #BP-45-10 ball puller.
For your T/C Hawken .l caliber, we recommend our #JS-50-vi-10 cleaning jag, and #BP-50-10 brawl puller.
For your T/C Hawken .54 caliber, nosotros recommend our #JS-54-half dozen-10 cleaning jag, and #BP-54-10 ball puller.
For your T/C Hawken .58 caliber, we recommend our #JS-58-6-10 cleaning jag, and #BP-58-10 ball puller.

For your 10 judge Pedersoli or Navy Arms shotgun, up to 30", order #JAG-ten-10 and #BP-75-10 puller.
For your 12 estimate Pedersoli or Navy Arms shotgun, upward to thirty", society #JAG-12-ten and #BP-69-10 puller.
For your twenty gauge Pedersoli or Navy Artillery shotgun, upwards to 30", order #JAG-twenty-10 and #BP-62-10 puller.
Note that very early on Pedersoli shotguns utilize our 11 judge or xiii gauge wads and accessories.

Save your wooden or synthetic ramrod for hunting or display. Employ this "trick" to pull a stuck patched ball:

1) Make the gun safe. Dismount the barrel, or remove the nipple.

ii) Pour in 2 or iii ounces of Runway's best #BORE-Make clean solvent, to soften fouling, penetrate the patch, and lubricate the stuck brawl.

three) Wait 30 minutes (not more), then drain and discard the above sovent. Do non allow information technology to stand up overnight, which might rust the bore.

four) Install Rails'south best #BP-fifty-10 ball puller (assuming .fifty caliber) on the rod. Or select the correct caliber.

5) Bump the the sharp tip of the ball puller into the stuck atomic number 82 round ball. Turn it in, two or three total turns.

6) Withdraw the stuck patched round ball. If the tip pulls out of the soft lead ball, turn it in a bit farther.

7) Clean your burglarize diameter using the remaining #BORE-CLEAN solvent and #OX-Clean-58-C flannel patches, and so oil the bore with #BC-PS-4 Barricade, or #RIG-3 Rust Inhibitor Grease, or WD-40, or whatsoever good water displacing oil.

This is our strongest cleaning and loading rod, designed to give a lifetime of service.